Carbon Filters; Removing Filter Panel/Filter; Changing The Light Bulbs - Pelgrim ISW 700 Notice D'utilisation

Carbon filters

The carbon filter must be used if the cooker
hood is not connected to a duct (see
extraction systems on page 9).
Note:
The carbon filter must be replaced at least
twice a year, depending on how much the
cooker hood is used.
Carbon filters cannot be cleaned to use
again.
Saturated carbon is harmful to the
environment, replace the filter regularly.
Assembling the carbon filter
C
P
U
Fig. 2. SLK 750/950
Press the feet (P) of the carbon filter (C) firmly
in the recesses in the filter panel (U).
Fig. 3. ISW 700/SLK 700
Centre the carbon filter with the sunken round
surface on top of the motor frame and turn it
to the right.

Removing filter panel/filter

Switch off the main switch.
C
B
D
Fig. 4. MSL 140 SLK 700/750/800/950
Pull out the visor (C). Press the handle (D)
slightly.
F
F
Fig. 5. ISW 700
Slide handles (F) in.
Push the brackets sideways and remove from
the filter panel. Clean the filter in soapy water.
Lay the coarse mesh of the filter face down on
the filter panel.

Changing the light bulbs

First switch the electricity off! If it is
necessary to change the starter or the light,
remove the plastic cover (B, see fig. 4).