Relay Outputs And Checkweighing - Adam Equipment Gladiator GGS 8 Mode D'emploi

For checkweighing in parts counting mode, use the directional buttons ⭡ or ⭣, scroll
through to the parts counting mode, "Count" will be shown on the display. Press [Tare/↵]
to confirm and follow the same process as outlined above.

6.7.1 Relay outputs and checkweighing

The relay outputs are open collector drivers to control an external relay. The relays will be
active when the corresponding LED is on during check-weighing. The ZERO relay output
will be on when the scale is showing the display is at Zero.
BOTH LIMITS SET
LOW LIMIT SET
HIGH LIMIT is set to
zero
HIGH LIMIT SET
LOW LIMIT is set to
zero
BOTH LIMITS SET.
LOW IS SET
GREATER THAN
HIGH
NOTE:
Weight must be more than 20 scale divisions for check weighing to operate. Below 20
scale divisions the LED's will not light and the beeper will not be on.
The display backlight will be green
when the weight is between the
limits
The display will be amber when the
weight is less than the Low Limit.
Above the Low Limit the display
backlight will be green,
The display will show a red
backlight until High limit is reached,
then green backlight above the
High limit. Beeper will turn on after
High limit.
This condition is not allowed.
CHK bP = In / out / off
The beeper will sound when the weight
is between the limits, i.e. OK
F3 bEP = bP OtL
Beeper will sound if weight is outside
the limits.
CHK bP = In
The beeper will be off when the weight
is less than the Low Limit.
Above the Low Limit the beeper will be
on
CHK bP = Out
The beeper will be on sound when the
weight is below the Low Limit
CHK bP = In
The beeper will be on when the weight
is less than the High Limit. Above the
High Limit the beeper will be off.
CHK bP = Out
When set to bP OtL the indicator alarm
will turn on below the high limit with red
backlight.
The beeper will be off when the weight
is below the High Limit, on when it is
above the High limit.