Selecting The Nozzle - Kärcher HDS 9/16-4 ST Gas Mode D'emploi

Masquer les pouces Voir aussi pour HDS 9/16-4 ST Gas:

Mode d'emploi (464 pages)

Table des Matières

Les langues disponibles

Set working pressure and flow rate

Appliance setting

 Turning the quantity regulation valve in clock-wise direction

will result in higher working pressure and larger volume.

 Turning the quantity regulation valve in an anti-clockwise di-

rection will result in lower working pressure and smaller quan-

tities.

Adjusting the pressure/quantity regulation of the trigger gun

(option)

DANGER

Risk of injury! When adjusting the pressure/quantity regulation,

make sure that the screw connection of the spray lance does not

become loose.

 Turning the water quantity regulator to the right gives more

water flow and higher working pressure.

 Turning the water quantity regulator to the left gives lesser

water flow and lower working pressure.

Operating with cold water

 Open the water supply.

Symbol "Engine on"

 Release the trigger gun. To do so, push the safety catch to-

wards the back.

 Open the trigger gun and set the appliance switch (A) to "1"

(motor on).

 The indicator lamp for operational readiness (F) shows that

the appliance is in stand-by mode and ready to be operated.

Operating with hot water

DANGER

Scalding danger!

ATTENTION

Hot water operations without fuel will cause damage to the fuel

pump. Ensure adequate fuel supply before starting hot water op-

erations.

If required, the burner can also be turned on subsequently.

Symbol "Burner on"

 Turn the appliance switch (A) to "Burner on".

 Set the desired water temperature on the thermostat (B).

Maximum temperature is 98 °C.

– If the trigger gun is closed during operation, the appliance will

switch off.

– The appliance will automatically start again when you open

the gun again within the stand-by period (2 ... 8 minutes).

– If the stand-by period is exceeded, the safety time mecha-

nism switches off the pump and the burner. The indicator

lamp Operations Stand-by (F) goes off.

– To restart the appliance, set the appliance switch to "0" and

then switch on the appliance again. If the appliance is operat-

ed using remote control, the appliance can be restarted by us-

ing the corresponding switch of the remote control device.

– Vehicle tyres are only cleaned using the flat spray nozzle

((25°) from a minimum spraying distance of 30 cm. The round

spray should never be used to clean tyres.

The following nozzles can be selected for all other tasks:

Dirt

Nozzle

strong

00060

medium

25060

light

40060

strong

00080

medium

25080

light

40080

Use the following nozzles if the pipe length is more than 20 m or

for more than 2 x 10 m high pressure hose NW8:

Dirt

Nozzle

strong

0075

medium

2575

light

4075

Operations stand-by