Cisco Systems Linksys WRT54GR Mode D'emploi page 47

Wireless-G Broadband Router with RangeBooster
5. I am not able to access the Setup page of the Router's web-based utility.
• Refer to "Problem #3, I want to test my Internet connection" to verify that your computer is properly
connected to the Router.
• Refer to "Appendix E: Finding the MAC Address and IP address for Your Ethernet Adapter" to verify that
your computer has an IP Address, Subnet Mask, Gateway, and DNS.
• Set a static IP address on your system; refer to "Problem #2: I need to set a static IP address."
• Refer to "Problem #10: I am a PPPoE user, and I need to remove the proxy settings or the dial-up pop-up
window."
6. I need to set up a server behind my Router and make it available to the public.
To use a server like a web, ftp, or mail server, you need to know the respective port numbers they are using.
For example, port 80 (HTTP) is used for web; port 21 (FTP) is used for FTP, and port 25 (SMTP outgoing) and
port 110 (POP3 incoming) are used for the mail server. You can get more information by viewing the
documentation provided with the server you installed.
Follow these steps to set up port forwarding through the Router's web-based utility. We will be setting up
web, ftp, and mail servers.
1. Access the Router's web-based utility by going to http://192.168.1.1 or the IP address of the Router.
Go to the Applications & Gaming => Port Range Forward tab.
2. Enter any name you want to use for the Application.
3. Enter the Start and End Port range of the service you are using. For example, if you have a web server,
you would enter the range 80 to 80.
4. Select the protocol(s) you will be using, TCP and/or UDP.
5. Enter the IP address of the PC or network device that you want the port server to go to. For example,
if the web server's Ethernet adapter IP address is 192.168.1.100, you would enter 100 in the field
provided. Check "Appendix E: Finding the MAC Address and IP Address for Your Ethernet Adapter" for
details on getting an IP address.
6. Check the Enable option for the port services you want to use. Consider the example below:
Application Start and End
Web server 80 to 80
FTP server 21 to 21
SMTP (outgoing) 25 to 25
POP3 (incoming) 110 to 110
When you have completed the configuration, click the Save Settings button.
Appendix A: Troubleshooting
Common Problems and Solutions
Protocol IP Address
Both 192.168.1.100
TCP 192.168.1.101
Both 192.168.1.102
Both 192.168.1.102
Enabled
X
X
X
X
41