Settings For Playback - Sony DSR-11 Mode D'emploi

Settings for Playback

Preparation on the player (this unit)
Note
Various text data are superimposed and output from the VIDEO jack or
the S VIDEO connector on the OUTPUT jacks. If you want to record
video signals without text data, carry out the following operations.
• Set TITLE DISP and LABEL DISP on the CM SET menu to OFF.
• Depending on the displayed items, press the MENU, DATA CODE,
DISPLAY or SEARCH SELECT button on the Remote Commander to
clear the text data on the monitor screen.
For details on text data, see "Displaying data recorded on a tape" on page 25
(GB) and "Displaying various data" on page 26 (GB).
For details on the CM SET menu, see "CM SET menu" on page 46 (GB).
1
Power on the video monitor, then set the monitor's input switch
according to the signals input from the recorder.
2
Set up the recorder.
For details, refer to the instruction manual of the recorder.
3
Power on this unit by pressing the ON/STANDBY switch on this unit.
4
When you play back a tape recorded in 4-channel mode (Fs32k),
adjust the balance between channel 1/2 and channel 3/4 with AUDIO
MIX on the AUDIO SET menu.
For details on the AUDIO SET menu, see "AUDIO SET menu" on page 44
(GB).
Note
The AUDIO MIX on the AUDIO SET menu (audio balance
adjustment) does not function on the source audio output through the
DV IN/OUT connector.
Chapter 2 Playback and Recording
23
(GB)