Settings For Playback - Sony DVCAM DSR-20 Mode D'emploi

Playback

Settings for Playback

Preparation on the player (this VCR)
Preparation on the recorder
16 EN
Chapter 2 Playback and Recording
1
Power on the video monitor, then set the monitor's input switches
according to the input signals from the recorder.
2
Set up the recorder.
For details, see "Preparation on the recorder" below.
3
Power on this unit by pressing the ON/STANDBY switch.
4
If the other equipment that controls this VCR has the time code
function, set the COUNTER SELECT switch to TC (see page 9).
5
When you play back an audio dubbed tape, set the AUDIO MONITOR
switch to MIX (see page 9). Then select the precise balance between
the tracks with the AUDIO MIX BALANCE in the menu (see page
34).
Note
With the DV connection, the playback VCR's AUDIO MONITOR (sound
selection) and AUDIO MIX BALANCE (audio balance adjustment) do not
function on the source audio output through the DV jack.
• Insert a tape for recording.
• Select the formats of video and audio input signal to be recorded.
• Set the LANC mode to M.
Notes
• Editing is not possible with a tape that is copyright protected.
• You cannot use the video equipment that has no LANC mode switch as a
recorder.