Flue Collar And Connection; Painting The Surround; Maintenance; Cleaning And Inspection - Nordpeis Q-34UL Manuel D'installation

Flue collar and connection

manufacturer
to let the varnish harden before any eventual masking
a designated masking tape. Carefully remove the tape
in order not to damage the varnish.
When the insert is installed and all instructions have
in order not to damage the Thermotte plates. Please
note that there might be some humidity in the insulation
humidity has evaporated.
smell.
not hazardous.
surfaface may become hot during operation.be hot and
that extra care need to be taken to avoid skin burn.
Finely chopped (diameter of 3-5cm)
Ca. amount pr lighting : 3 kg
Place the air vent control in ignition mode (B). Insert
can be inserted. Pull the hot ember to the front of the
20
Reload size
Normal load size. 2,5kg /h
should this happen. Regulation of the air vent control

6. Maintenance

The insert should be inspected thoroughly and cleaned
at least once per season (possibly in combination
or deformed.
need a better air supply than normally. Open vents or
inspected.

Ashes

The ashes should be removed at regular intervals.
of non-combustible material to remove the ashes. It is
recommended to leave a layer of ashes in the bottom
as this further insulates the burn chamber. Take care
damage them.
These insulating plates in the burn chamber (FIG 7)
GB