Nordpeis Q-34UL Manuel D'installation page 23

se of combustion problems
Error
The chimney is blocked.
central ventilation system that pulls too much air out of
the room.
the same chimney at the same height.
to the chimney.
The insert
release smoke
Soot hatch in the basement or attic that is open and thus
creating a false draught.
-
not in use are open and create a false draught.
tion
been removed, thus creating a false draught.
Defect masonry in the chimney, e.g. it is not airtight
the chimney creating a false draught.
The cross-section in the chimney is too small and the
chimney cannot carry out all the smoke.
releases smoke terrain, buildings, trees etc.
inside when
Turbulence around the chimney due to the roof being
outside.
does not heat
Too much
The chimney is too large.
The air vent control is closed too tightly.
Smoke is
A levelling out of pressure occurs in the burn chamber.
released when
the door is
opened
chamber.
White smoke
black smoke
Explanation
be installed in the room.
vents must be installed.
pipes must be of at least 30 cm.
from smoke dome to chimney. Possibly install a smoke suction device*.
suction device*.
defected must be changed.
use.
Seal and plaster all cracks and sites that are not tight.
section. Possibly install a smoke suction device*.
Increase the height of the chimney and/or install a chimney cap/smoke
suction device*.
Increase the height of the chimney and/or install a chimney cap/smoke
suction device*.
Increase the height of the chimney and/or install a chimney cap/smoke
suction device*.
a damper can reduce the chimney draught. NB! A leakage of only 5 cm2
-
is enough for 30% of the heated air to disappear.
Replace the gaskets, contact your dealer.
Open the air vent control for about 1 min before opening the door –
Increase the air supply.
Increase the air supply.
GB
Solution
23