Switching Off The Engine - Ayce RMB46 SHW BS500E 2.6 PS Mode D'emploi D'origine

6.4 Switching off the engine

All you have to do to switch off the engine is release the engine start/stop lever
(Fig. 5a/Item 1a). Pull off the spark plug connector from the spark plug in order
to prevent the engine from starting. Before you start the engine again, check the
cable of the engine brake. Check that the actuator cable is correctly fitted. If the
switch-off cable is kinked or damaged, it must be replaced.
6.5 Emptying the debris bag
When the debris bag is full, the air throughput will be low and the level indicator
(4c) will be up close against the debris bag (Fig. 9). Empty the debris bag and clear
out the ejector chute.
Danger! Before taking off the debris bag, switch off the engine and wait until the
blade has come to a stop.
To take off the grass basket, use one hand to lift up the chute flap and the other to
grab onto the basket carry-handle. Remove the basket (Fig. 4a).
4a
5a 5a
9
1
2
4a
For safety reasons, the chute flap automatically falls down after removing the
grass basket and closes off the rear chute opening. If any grass remains in the
opening, it will be easier to restart the engine if you pull the mower back approxi-
mately 1m.
Do not use your hands or feet to remove clippings in or on the mower housing, but
instead use suitable tools such as a brush or a hand broom.
In order to ensure that the majority of grass clippings are picked up, the inside of
both the grass bag and especially the air grill must be cleaned after each use.
Reattach the grass bag only when the engine is switched off and the blade is stop-
ped.
Using one hand, lift up the chute flap, while grabbing onto the basket handle with
the other. Hang in the basket from the top.