Cleaning, Maintenance, Storage, Transport And Ordering Of Spare Parts; Petrol Engine - Ayce RMB46 SHW BS500E 2.6 PS Mode D'emploi D'origine

Table des Matières

Les langues disponibles

96 I 97

7. CLEANING, MAINTENANCE, STORAGE, TRANSPORT AND

ORDERING OF SPARE PARTS

Danger!

Never work on or touch any current-conducting parts of the ignition system while

the engine is running. Pull the spark plug boot from the spark boot before doing

any maintenance or assembly work. Never carry out any work on the equipment

while the engine is running. Work that is not described in these operating instruc-

tions, should only be carried out by authorized workshops.

7.1 Cleaning

The lawn mower should be cleaned thoroughly every time after it has been used.

This applies in particular to its underside and the blade mount. Tilt the lawn mo-

wer to the rear by pressing down the push bar.

Note: Before tilting the lawn mower, use a petrol extraction pump to drain all the

fuel out of the fuel tank. Do not tilt the lawn mower by more than 90 degrees. It is

easiest to remove dirt and grass immediately after mowing. Dried grass remnants

and dirt may impair the mowing operation. Check whether the grass ejector chute

is free of grass residues and clear out as required. Never clean the lawn mower

using a water jet or a high-pressure cleaner. Ensure that no water can get into

the interior of the equipment. Do not use aggressive cleaning agents such as cold

cleaners or petroleum ether.

7.2 Maintenance

Note: Dispose of soiled maintenance material and operating materials at the ap-

propriate collection point.

The enclosed engine manual from Briggs & Stratton provides maintenance in-

formation and maintenance interval information on the engine.

7.2.2 Blades

For safety reasons, have all blade sharpening, balancing and mounting work car-

ried out by an authorized service center. To achieve optimal results, we recom-

mend having the blades checked once a year.

Changing the blades (Fig. 7)

When changing the cutting unit, be sure to use only genuine replacement parts.

The identification mark on the blade must correspond with the number specified in

the spare parts list.

Never install a blade from a different manufacturer.

Table des Matières