Adjusting The Cutting Height; Adjusting The Handle Height - Ayce LM-C4205 Traduction De La Notice Originale

ASSEMBLY OF GRASS BOX
Fig. 5
Fig. 7
Fig. 9
- Insert the handle into the grass box's cover. See Fig 5
- Assemble the left part and the right part of the grass box together. Fig. 6
- Insert the grass box's cover into the grass box and fix the edge of both side first. Fig. 7
- Hook the grass box's cover on the grass box. Fig. 8
- Insert grass lead board into the grass box. Fig. 9
- Lift the guard (9) and hold up, fit the grass box (16). Fig. 10
PREPARATION

ADJUSTING THE CUTTING HEIGHT

Warning: release switch level, unplug the machine and wait until the motor stops before
adjusting height. The blades continue to rotate for a few seconds after the machine is switched
off, a rotating blade can cause injury.
Fig. 6
Fig. 8
Fig. 10
Select the cutting height by locking the lever in the desired position. (move lever outward, slide to
correct position, move inward to lock it again) (See fig 11)
From rear to front, the adjustable height is from 25mm to 85mm.
Remark: For the first cut of the season, a high cutting position should be selected.

ADJUSTING THE HANDLE HEIGHT

You can easily adapt the height of the handle, by changing it's
angle.
Release the clamping levers (15) at both sides of the lower
handle part, select the desired height position of the handle by
moving it upwards (or downwards), then re-lock the clamping
levers.
This enables you to adapt the handle upright height from 900
mm to 1050 mm in 3 different positions.
Fig. 12
EXTENSION CABLE / CABLE HOOK
Power connection
Use only extension cables (max. 50 m), which are suitable for outdoor use according to IEC 60320-
2-3.3 e.g. H07RN-F 3x1,5 mm² down to - 25°C H07BQ-F 3x1,5 mm² down to - 40°C.
The mains voltage (230V) indicated on the rating plate must correspond with the mains power
supply. Mains connection fuse: min.10A.
1) Insert the mains plug of the unit connection plug.
2) To prevent the extension cord from disconnecting during use, tie the end of the extension cord
into the cable hook before connecting the plug on the switch housing of the mower.
Note: Ensure that the cable hooks are used to fix the cable to the handle
Attach extension cable to cable hook ensuring that sufficient cable slack is available
68 69
Fig. 11
Fig. 13
GB