Troubleshooting Guide - Ayce RMB46 SHW BS500E 2.6 PS Mode D'emploi D'origine

9. Troubleshooting guide

Warning: Switch off the engine and pull out the spark plug boot before making any
checks or adjustments.
Warning: If, after making an adjustment or repair to the engine, you let it run for a
few minutes, remember that the exhaust and other parts will get hot. Do not touch
these parts as they may burn you.
Important. If problems arise in connection with the engine, please refer to the
enclosed manual from Briggs & Stratton.
Fault
The equipment - Bolts loose
does not ope- - Blade attachment is loose
rate smoothly - Blade imbalanced
and vibrates
intensively
The engine - Engine start/stop lever is
does not start
- Throttle lever in wrong posi-
- Spark plug defective
- Fuel tank empty
- Fuel pump (primer) not ac-
Engine does - Air filter dirty
not run - Spark plug dirty
smoothly
Lawn turns - Blade is not sharp
yellow, uneven - Cutting height too small
cut - Engine speed too low
Grass chute is - Engine speed too low
not clean - Cutting height too small
- Blade is worn
- Grass bag is clogged
Possible cause
not pressed
tion (if provided)
tuated (if provided)
Remedy
- Check bolts
- Check blade attachment
- Replace blade
- Press the engine start/stop
lever
- Check setting (if provided)
- Replace spark plug
- Top up fuel
- Actuate the fuel pump (pri-
mer) (if provided)
- Clean the air filter
- Clean the spark plug
- Sharpen blade
- Adjust to the proper height
- Set the throttle lever to
max. (if provided)
- Set the throttle lever to
max.
- Set properly
- Replace the blade
- Empty the grass bag