Cleaning The Pre-Filter And Particle Sensor; Cleaning The Pre-Filter; Cleaning The Particle Sensor - Boneco H680 Instructions D'utilisation

44
CLE ANING THE PRE-FILTER AND PARTICLE SENSOR
en

CLEANING THE PRE-FILTER

The pre-filter prevents excessive dust accumulation from
getting inside the BONECO H680.
1. Clean the pre-filter under running water or using a
vacuum cleaner.

CLEANING THE PARTICLE SENSOR

The particle sensor detects the amount of dirt in the air
in the room by analyzing a passing air stream. Over time,
dirt can accumulate and affect measuring accuracy.
The flap over the particle sensor has to be closed during
operation to ensure the measurement is correct. It should
only be opened to clean the sensor.
Do not use alcohol or corrosive cleaning agents for
cleaning.
1. Wipe the sensor lens using a damp cotton swab.
2. Dry the sensor with a dry cotton swab.