Manually Regulating Humidity And Fan Level; Perfect Humidity; Controlling Humidity; Maximum Humidification - Boneco H680 Instructions D'utilisation

MANUALLY REGUL ATING HUMIDIT Y AND FAN LEVEL

PERFECT HUMIDITY

The recommended humidity level is between 40% and
60%. The default setting is 50%. The indicator for current
humidity should ideally be within the "OK" range:
The humidity you set then stays saved if you switch off
the appliance.

CONTROLLING HUMIDITY

1. Press the and buttons to set the humidity as
desired.
The notice is shown on the display. Once you
stop pressing the arrow keys, the notice switches to
after a few seconds. Now the display now
shows the current humidity again.

MAXIMUM HUMIDIFICATION

Press the button until the notice "Co" (for "Continu-
ous") is displayed. Now the evaporator operates indepen-
dently of the measured humidity.

REGULATING THE FAN LEVEL

1. Press the button once. The indicator for the fan
level flashes.
2. Press the and buttons to adjust the fan level.
3. To switch back to the comfort mode, press the
button on the appliance until the
shown on the display. Alternatively, you can also use
the button on the remote control.

POWER LEVEL (P)

The maximum power level (P) can only be selected manu-
ally. We recommend using it when room air has to be
cleaned and/or humidified in the shortest possible time.
To activate the maximum power level, press the
ton repeatedly until "P" is shown in the indicator for the
fan level (see figure in the left column).
39
en
notice is
but-