Luminance Brands KATHY IRELAND ATOMICAL LED CF930LBS00 Mode D'emploi page 8

3. Ceiling Fan Assembly
3.10
While pulling up on the 4 .5" Downrod, retighten the Two
Phillips Head Set Screws to secure the 4 .5" Downrod in
the Motor Coupler (Figure 10) .
NOTE: The Set Screws must be properly installed
as described above, or fan wobble could result.
WARNING
!
It is critical that the set screws in the motor coupler are
properly installed and securely tightened. Failure to
verify that the set screws are properly installed could
result in the fan falling.
3.11
Make sure the Grommet is properly installed in the
Coupler Cover, then slide the Coupler Cover on the
4 .5" Downrod until it rests on the Motor Housing
(Figure 11) .
3.12
Place the Ceiling Cover over the 4 .5" Downrod
(Figure 12) .
Be sure that the Ceiling Cover and the Coupler Cover
are both oriented correctly (Figure 12) .
(Continued)
RETIGHTEN TWO
PHILLIPS HEAD
SET SCREWS
Figure 10
Figure 11
Figure 12
8
MOTOR
COUPLER
4.5" DOWNROD
GROMMET
COUPLER
COVER
U.L. Model No.: CF930L