Luminance Brands KATHY IRELAND ATOMICAL LED CF930LBS00 Mode D'emploi page 6

3. Ceiling Fan Assembly
3.4
P o s i t i o n t h e L o w e r H o u s i n g o n t o t h e F a n
Motor Assembly by rotating the Lower Housing
Counter-Clockwise to engage the Two loosened
#8-32 x 10 mm Serrated Pan Head Screws in the
Two Key Slots (Figure 4) .
3.5
Reinstall the previously removed #8-32 x 10 mm
Serrated Pan Head Screw into the Lower Housing
(Figure 5) .
Secure the Lower Housing by tightening the Three
#8-32 x 10 mm Serrated Pan Head Screws (Figure 5) .
A spare #8-32 x 10 mm Serrated Head Pan Screw
supplied in parts bag, if needed .
The LED Light Fixture Assembly will be installed during
the Final Assembly, after Ceiling Fan is hung and
wired .
3.6
Carefully turn the partially assembled Ceiling Fan right
side up and place the Fan securely into the packing
styrofoam .
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 4 .5" Downrod (Figure 6) .
Remove the Pin from the 4 .5" Downrod, then remove
the Hanger Ball (Figure 6) .
Retain the Pin and Hanger Ball for reinstallation in
Step 3 .13 .
NOTE: Do not loosen the Screw that attaches the
Green Ground Wire to the Hanger Ball.
(Continued)
LOWER
HOUSING
ROTATE COUNTER-CLOCKWISE
Figure 4
LOWER
HOUSING
Figure 5
PIN
PHILLIPS HEAD SET SCREW (LOOSENED)
Figure 6
6
TWO LOOSENED #8-32 x 10 mm
SERRATED PAN HEADS
SCREWS
TWO KEY
HOLE SLOTS
REINSTALL ONE
#8-32 x 10 mm SERRATED
PAN HEAD SCREW
RETIGHTEN TWO
#8-32 x 10 mm
SERRATED PAN
HEAD SCREWS
GREEN GROUND WIRE
4.5" DOWNROD
HANGER BALL
U.L. Model No.: CF930L