Test Sewing - JUKI TL-2200QVP Mini Manuel D'instructions

Test sewing

CAUTION:
If you start sewing while the thread take-up is engaged in its ascending motion, the needle thread may slip
out of the needle's eye.
18
Do not place anything on the foot controller which is set to the sewing machine.
1
Place the material
under the presser
foot, and lower the
presser foot.
3
Start to run the sewing machine.
Do not pull the material by hand while it is being sewn.
4
When the sewing is finished, stop the
sewing machine and actuate the thread
trimmer.
Press the automatic thread trimming switch or depress
the thread trimming foot switch. When actuating the au-
tomatic thread trimmer, the needle will stop in its highest
position after trimming. (If you use a thread as thick as
count #20 or more or a special-kind of thread, manually
cut the thread using a pair of scissors.)
* After the thread trimming, you can re-start sewing even
if the bobbin thread does not appear on the throat plate.
5
Raise the presser foot, and take out the
finished material.
2
Lower the needle.
Turn the handwheel
toward you or press the
needle up/down switch
to drop the needle on
the material.