Winding The Bobbin; Installing The Thread Guide - JUKI TL-2200QVP Mini Manuel D'instructions

Winding the bobbin

CAUTION:
4
1
2
Bobbin winder guide
12
Turn OFF the power switch when opening the slide plate.
3
Bobbin presser

Installing the thread guide

1 Raise the support rod fully, turning slightly until the posi-
tioning latches engage.
2 Set the large spool over the anti vibration cone, or
3 Set the household-type thread onto the spool pin and then
insert a spool cap in place.
4 Pass the thread coming from the spool on the thread
guide pin (rod) just above the spool.
Positioning latches
Bobbin thread
winding shaft
1
Take out the bobbin case.
Bring up the needle. Opening the slide plate, take out
the bobbin case.