Table des Matières
Publicité
Battery and Charging System
Standby
Position
Inserting Battery
1.
L
o
a
d
h t
e
b
t a
e t
y r
c ,
Nailer.
2. Push battery fully forward into its locked Ready
position. The battery indicator light will light.
3.
To disengage the battery, push down on locking
tab and slide battery back until it locks into the
Standby position.
4. To remove battery, push down on locking tab and slide
battery out.
8
! TOOL OPERATORS AND BYSTANDERS MUST WEAR EYE AND HEARING PROTECTION THAT CONFORMS TO ANSI
STANDARDS.
! ASSUME TOOL IS ALWAYS LOADED AND WILL ALWAYS FIRE A FASTENER.
! CARBON MONOXIDE HAZARD - USE ONLY IN VENTILATED AREA TO AVOID NAUSEA AND UNCONSCIOUSNESS.
! EXPLOSION HAZARD - NEVER USE IN EXPLOSIVE ATMOSPHERE - TOOL EXHAUST COULD IGNITE FUMES.
! KEEP FINGERS AWAY FROM TRIGGER. NEVER POINT TOOL AT ANYONE OR YOURSELF.
Ready
Position
fi
o
n
a t
c
s t
s r
, t
n i
o t
h t
e
Impulse
Battery Indicator Light
On the right side of the handle is a small plastic lens. This is
the battery indicator light. When you insert a fully-charged
battery into the tool, you will see a blinking green light. If
the indicator light blinks red, recharge the battery.
BATTERY INDICATOR LIGHT
F
n i
s i
h
NOTE: If battery is left in tool for an extended period,
the battery will discharge completely and will require
recharging.
! TOOL OPERATORS AND BYSTANDERS MUST WEAR EYE AND HEARING PROTECTION THAT CONFORMS TO ANSI
STANDARDS.
! ASSUME TOOL IS ALWAYS LOADED AND WILL ALWAYS FIRE A FASTENER.
! CARBON MONOXIDE HAZARD - USE ONLY IN VENTILATED AREA TO AVOID NAUSEA AND UNCONSCIOUSNESS.
! EXPLOSION HAZARD - NEVER USE IN EXPLOSIVE ATMOSPHERE - TOOL EXHAUST COULD IGNITE FUMES.
! KEEP FINGERS AWAY FROM TRIGGER. NEVER POINT TOOL AT ANYONE OR YOURSELF.
Publicité
Table des Matières
