Battery And Charging System; Inserting Battery - Paslode IM200Li.2 Manuel D'utilisation

Battery and Charging System

Ready
Position

Inserting Battery

1. L o a d h t e b t a e t y r
Brad nailer
2. Push battery fully forward into its locked Ready
position. The battery indicator light will light.
3. To disengage the battery, push down on locking
tab and slide battery back until it locks into the
Standby position.
4. To remove battery, push down on locking tab and
slide battery out.
8
Standby
Position
c , o n a t c s t s r , t n i o t h t e Cordless
Battery Indicator Light
On the right side of the handle is a small plastic lens. This is
the battery indicator light. When you insert a fully-charged
battery into the tool, you will see a blinking green light. If
the indicator light blinks red, recharge the battery.
BATTERY INDICATOR LIGHT
NOTE: If battery is left in tool for an extended period,
the battery will discharge completely and will require
recharging.