Loading Fasteners - Paslode IMPULSE IMLi200 Manuel D'utilisation

Preparing the Impulse 18 ga. Brad Nailer for Use
Fasteners
The Paslode Impulse 18 ga. Brad Nailer drives Paslode
18 gauge fasteners designed to be used with the tool.
The use of fasteners that do not meet Paslode standards
could cause tool damage and will void all warranty
claims.

Loading Fasteners

Step 1: Press the release latch with your thumb and pull the
rail cover to the full open position.
Step 2; Place the 18 gauge brad nails into the rail with the
points resting in the bottom of the rail.
Step 3: Slide the rail cover forward to the locked postion.
In the illustration above, you will see an indicator arrow on
the side of the follower. When the indicator arrow is in the
reload area, marked on the side of the magazine, you may
insert a new strip of nails.
12
®
Pull
Follower
Paslode Impulse™ 18 ga. Brad
Nailer and Outdoor Weather
Use the Impulse Brad Nailer outdoors, in dry weather,
when the nailer, fuel cell, and battery are between
20°F (-7°C) and 120°F (49°C).
HOT WEATHER OPERATION
The Impulse Brad Nailer requires cooling of the
motor assembly to operate properly. The fan normally
provides the necessary air flow to permit continuous
operation. Whenever the Impulse Brad Nailer is idle
for extended periods, keep the fuel and tool out of
direct sunlight and in surroundings where temperatures
will not exceed 120°F (49°C). After extended periods
of continuous use, it may be necessary to cool the
Impulse motor by setting tool aside for 10-15 minutes
or until the tool operates normally. An overheated tool
may not drive nails completely or may operate
erratically.
COLD WEATHER OPERATION
Fuel cells at cold temperatures lose the required
propellant pressure. Bring the tool, fuel cell, and
battery above 20° F (-7° C) by placing the tool in a
heated building or vehicle. Never expose the tool,
fuel cell or battery to flame
CAUTION
The Impulse Brad Nailer should not be used in
the rain or where excessive moisture is present.
The use of the Paslode Impulse™ Technology
under these conditions may result in damage to
tool components and cause the tool to
malfunction.