Paslode IMPULSE IMLi200 Manuel D'utilisation page 9

Battery and charging system
The Paslode Impulse 18 Gauge Straight Lithium-ion
Brad Nailer comes with a rechargeable battery and
its own charging system. This charging system is
the only one that will work with the Paslode
lithium-ion batteries. The first step in preparing a
new tool for operation is to fully charge the battery.
New batteries are shipped partially discharged
and must be charged prior to first use. Batteries
will take 5 minutes to 1 hour (time will be dependant
on the amount of discharge of the battery) to
recharge.
Important Charging Notes:
CHEMICAL/EXPLOSION
HAZARD
Read ALL instructions be-
fore charging or using bat-
tery. Failure to follow ALL
instructions may result in
fire, severe burns, or re-
lease of toxic materials.
Battery
THE PASLODE BATTERY CHARGING SYSTEM
Charging System Accessories:
Battery Charger - Part No. 902667
Battery and Charging System
Charging Instructions
1.
2. Remove the battery from tool or case and insert ter-
Warning
3. After charging is complete, the red light will go out
4. Unplug the charger from the 120V AC outlet.
Charging Times
Charging Donʼts
6ft. Cord
1. Do not charge battery outdoors or in temperatures
2. Do not allow metal objects to come in contact with
3. Do not puncture or attempt to open battery case or
4. Do not store battery where it will be subjected to
Charger
5. Do not incinerate battery.
6. Do not use a defective battery charger, one that
7. Do not immerse the battery or charger in water.
Remove the charger unit from the tool case and plug
it into a 120V AC outlet. Set the charger base on a
stable surface. A green light will come on to indicate
the power is on and the charger circuit is ready.
minals down into charger. The red light will come on
indicating that the battery is charging and the green
light will go out.
Note
If battery is completely discharged, the red light and
the green light may alternate back and forth for up to
20 minutes. This safety feature slowly recharges the
battery until it is ready to accept the full charging
current. If the red and green lights continue to alter-
nate after 20 minutes, replace the battery.
and the green light will come on, indicating that the
battery is fully charged. The charger will keep the
battery at full charge until it is removed.
First charge (new battery)
Discharged Battery
below 40°F (5°C).
battery terminals.
cells.
temperatures above 120°F (49°C).
over-heats and/or smokes when plugged in.
1 hour
5 minutes to 1 hour
7