Auriol 101503-14-01 Instructions D'utilisation Et Consignes De Sécurité page 9

described above) and take out the segment .
7
Note: If you would like to take out more than one consecutive
segment , it is sufficient to remove the two outer pins.
7
Connect the watch strap together again by joining the loose
segments with a pin. Press this pin against the direction of the
7
arrow into the adjacent segments .
7
Note: In order to remove one or more segments
directly on
7
the fastener , press out the spring bar with the slider ,
6 9
remove the fastener and proceed as described above.
6
How to exchange the pin inside the slider
(Fig. F,G,H)
Take out the slider , open the bottom cover with the spare
9 11
pin inside.
10
You will need the pliers to carefully remove the old pin from the
slider.
Insert the spare pin carefully into the slider by again using the
pliers. The new pin is installed.
GB/IE 9
101503_SE_DK_NL_BE.indd 9 8/6/2014 11:40:57 AM