Correct Posture; Measuring Blood Pressure - Sanitas SBC 27 Mode D'emploi

5. Measuring blood pressure

Positioning cuff
• Bare your left wrist, making sure that the circulation in the
arm is not restricted by any clothes etc. that are too tight.
Position the cuff on the inside of your wrist.
• Fasten the cuff with the Velcro fastening so that the upper
edge of the monitor is positioned approx. 1 cm below the
ball of your thumb.
• The cuff has to be fitted tightly around the wrist but should
not constrict it.

Correct posture

• Rest for approx. 5 minutes before each measurement. Oth-
erwise there may be divergences.
• You can perform the measurement ei-
ther sitting or lying down. It is essential
to support your arm and have it at an
angle. Always make sure that the cuff
is level with your heart. Otherwise there
may be serious divergences. Relax
your arm and the palms of your hands.
• In order not to distort the result, it is important to keep still
during the measurement and not talk.
Select memory
Switch on the blood pressure monitor with the
the required memory space by pressing the function key "+".
You have two memories (60 memory spaces each) in order to
save the test results of 2 different people separately, or else
save measurements in the morning and evening separately.
Measuring blood pressure
• Put on the cuff as described previously and assume the posi-
tion in which you want to carry out the measurement.
• Using the buttons
measurement process by pressing button
the display with all digits lighting up, the monitor will automati-
cally inflate. Following the self-test, during which all display
elements briefly appear, the measurement begins. During
inflation the device already determines measured values used
to estimate the required inflation pressure. If this pressure is
insufficient, the device automatically inflates by another.
• Then the pressure in the cuff is slowly released and the pulse
is measured.
• When the measurement has been completed, the remain ing
air pressure is released very quickly. The pulse, the systolic
and the diastolic blood pressure are displayed.
• You can interrupt measurement at any time by pressing the
button
• • • • • • • • • • • • •
• The E_ icon appears if it has not been possible to perform
the measurement properly. Observe the section in these in-
structions on error messages/troubleshooting and repeat the
measurement.
• The device switches off automatically after 1 minute.
Wait at least 5 minutes before taking another measurement!
13
, select the user memory 1 or 2. Start the
.
button. Select
. After checking