Correct Posture; Measuring Blood Pressure - Sanitas SBC 28 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
2. At any time:
• Press the
button to display the date/time and current user
memory.
• Press and hold the
set time/date.
• Set as described above.

5. Measuring blood pressure

Positioning cuff
1
2
• Bare your left wrist, making sure that the circulation in the
arm is not restricted by any clothes etc. that are too tight.
Position the cuff on the inside of your wrist.
• Fasten the cuff with the Velcro fastening so that the upper
edge of the monitor is positioned approx. 1 cm below the
ball of your thumb.
• The cuff has to be fitted tightly around the wrist but should
not constrict it.
button again for about 3 seconds to
3

Correct posture

• Rest for approx. 5 minutes before each measurement. Oth-
erwise there may be divergences.
• You can perform the measurement ei-
ther sitting or lying down. It is essential
to support your arm and have it at an
angle. Always make sure that the cuff
is level with your heart. Otherwise there
may be serious divergences. Relax
your arm and the palms of your hands.
• In order not to distort the result, it is important to keep still
during the measurement and not talk.
Select memory
Press the
button to display the date/time and current user
memory. Select the desired user memory by pressing the
function button. Confirm your selection with the
You have two memories (60 memory spaces each) in order to
save the test results of 2 different people separately, or else
save measurements in the morning and evening separately.
Measuring blood pressure
• Put on the cuff as described previously and assume the posi-
tion in which you want to carry out the measurement.
• Select the user memory using or . Start the measurement
process by pressing button
tomatically. Following the self-test, during which all display
elements briefly appear, the measurement begins. During
inflation the device already determines measured values used
to estimate the required inflation pressure. If this pressure is
insufficient, the device automatically inflates by another.
14
• • • • • • • • • • • • •
button.
. The cuff pumps itself up au-

Publicité

Table des Matières
loading

Table des Matières