Cleaning The Interior; Main Components - Modular 70/40 PCG Série Manuel D'installation, D'emploi Et D'entretien

- Reassemble all parts. For assembly, proceed in
reverse order.
CONVECTION OVEN
REPLACING THE KNOB AND INDICATOR LIGHT
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE WORKING THERMOSTAT AND
SAFETY THERMOSTAT
- Remove the control panel.
- Remove the bulb from its seat on the side of the
oven.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE HEATING ELEMENT
- Remove the oven floor (only for lower heating
elements).
- Undo the screw securing the element to the oven
and pull the element out by approx. 10 cm.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE MOTOR
-
Remove the oven floor.
- Remove the interior panel
- Remove the engine support.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.

24. CLEANING THE INTERIOR

Check the condition of the inside of the
appliance.
Remove any built-up dirt.
Check and clean the fumes exhaust system.

25. MAIN COMPONENTS

GAS HOB
- GAS COCK
- MAIN BURNER
- Pilot burner
- Thermocouple
GAS SOLID TOP RANGES
- GAS COCK
- MAIN BURNER
- Pilot burner
- Thermocouple
- Igniter
- Piezoelectric ignition
GAS OVEN
- Gas valve
- MAIN BURNER
- Pilot burner
- Thermocouple
- Igniter
- Piezoelectric ignition
ELECTRIC HOB
- Control knob
- Hotplate
- Indicator light
ELECTRIC OVEN
- Control knob
- Working thermostat
- Safety thermostat
- Heating element
- Indicator light
CONVECTION OVEN
- Control knob
- Working thermostat
- Safety thermostat
- Heating element
- Indicator light
- engine
- fan
34