Modular 70/40 PCG Série Manuel D'installation, D'emploi Et D'entretien page 25

To convert the appliance to the local gas type,
follow the instructions given in TAB1 andcarry
out the steps below:
- Replace the main burner nozzle (UM).
- Adjust the main burner's air regulator to distance
A.
- Replace the pilot burner nozzle (UP).
- Adjust the pilot burner air " ow (if necessary).
- Replace the gas valve minimum nozzle (Um).
- Affix the adhesive tab indicating the new type of
gas used.
- The nozzles and adhesive tabs are supplied with
the appliance.
GAS HOB
REPLACING THE MAIN BURNER NOZZLE
Remove the control panel.
Remove the panstand grids and burners.
Remove nozzle UM and replace it with the one
indicated in table TAB1.
Retighten nozzle UM.
Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE MINIMUM
SCREW
Remove the control panel.
Remove nozzle UM and replace it with the one
indicated in table TAB1.
Retighten nozzle UM.
Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE PILOT BURNER NOZZLE
Remove the control panel.
Remove the 3 screws securing the venturi to the
hob and pull the venturi out by approx. 10 cm.
Undo connector R.
Remove nozzle UP and replace it with the one
indicated in table TAB1.
Retighten connector R. Reassemble all parts.
Following, in reverse order, the sequence used
for their removal.
GAS SOLID TOP RANGES
ADJUSTMENT
25
REPLACING THE NOZZLE AND THE MAIN BURNER
PRIMARY AIR REGULATION
Remove the control panel.
Remove nozzle UM and replace it with the one
indicated in table TAB1.
Retighten nozzle UM.
Slacken screw V and position the air regulator at
distance A as indicated in table TAB1.
Retighten screw V fully.
Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE MINIMUM
SCREW
Remove the control panel.
Remove nozzle UM and replace it with the one
indicated in table TAB1.
Retighten nozzle UM.
Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE PILOT BURNER NOZZLE
Remove the hotplate.
Remove the control panel and internal guards.
Undo connector R.
Remove nozzle UP and replace it with the one
indicated in table TAB1.
Retighten connector R. Reassemble all parts.
Following, in reverse order, the sequence used
for their removal.
GAS OVEN
REPLACING THE NOZZLE AND THE MAIN BURNER
PRIMARY AIR REGULATION
Open the oven door.
Remove the panel on the oven door.
Slacken screw V.
Remove nozzle UM (fitted to air regulator Z) and
replace it with the one indicated in table TAB1.
Retighten nozzle UM (fitted to air regulator Z).
Adjust air regulator Z to distance A as shown in
table TAB1.
Retighten screw V fully.
Reassemble all parts. For assembly, proceed in
reverse order.
ADJUSTMENT