Maintenance; Using Midwest ® Plus Automate Spray Can; To Change Automate Absorption Pad And Particulate Filter; To Change Automate Particulate Filter - Dentsply Sirona MIDWEST AUTOMATE Mode D'emploi

5 Maintenance

5 Maintenance
®
Using Midwest Plus Automate Spray Can
Insert Spray Can
Open side door.
Lift lever and hold.
Fully seat spray can in holder.
Release lever.
Close side door.
NOTE:
Use only original Midwest
Remove spray can
Open side door.
Lift lever and hold.
Tilt bottom of can outwards.
Pull can out.
Release lever.
Close side door.
Disposing empty spray cans
Follow local regulations for disposal.
Safety information
Check for any leaks every time a new bottle is installed!
Replace faulty or leaky spray cans immediately!
Protect the spray can from direct sunlight!

To change automate absorption pad and particulate filter

Open the front door.
Pull out and remove saturated absorption pad from the two holding brackets.
Hang new absorption pad on to the two holding brackets.
Close the front door.
NOTE:
Use only original Midwest
It is recommended to replace the absorption pad each time a new Midwest
frequently as needed.

To change automate particulate filter

NOTE:
It is recommended to replace the particulate filter at every third time a new absorption pad is replaced or as necessary.
Open the front door.
Pull out and remove yellow particulate filter at the bottom of the unit behind the absorption pad.
Place a new particulate filter with the yellow side faced down.
Ensure absorption pad is positioned back in place.
Close the front door.
NOTE:
Use only original Midwest
®
Plus Automate Spray Cans.
®
Absorption Pads and Particulate Filters
®
Particulate Filters (included in the Midwest
Insert Spray Can
®
Plus Automate Spray Can is used, or more
® ®
Automate
M
IDWEST
9
Automated Handpiece Maintenance System
Remove Spray Can
Absorption Pad Kit).
®
A
®
UTOMATE
EN