Siemens SIPART PS2 6DR5 Serie Notice De Service page 23

The rear steel panel of the NCS sensor is inevitably bonded to the ground potential of the system when mounting on the
console. This ground connection is only functional if there is a low-impedance connection to ground potential of the
system. Ensure this state by measuring the ground resistance. If necessary, ensure proper grounding by means of an
additional cable from the NCS sensor to ground potential.
4.2.6 Connecting the external position detection system to the EMC filter module
Requirement
You need the EMC filter module with article number C73451-A430-D23 for the electrical connection of an external position
detection system, article number C73451-A430-D78, to the positioner.
Wiring diagram
①
EMC filter module terminals
②
Positioner with integral EMC filter module C73451-
A430-D23
③
Yellow wheel for locking the position detection
④
Ribbon cable connector of fitted potentiometer, or
ribbon cable connector of EMC filter module
⑤
Basic electronics
⑥
Screw
⑦
EMC filter module C73451-A430-D23
Figure 4-8 Connection to positioner
SIPART PS2 (6DR5...)
A5E03436620-07, 10/2015
⑧
External position detection system C73451-A430-
D78
⑨
External position detection system terminals
⑩
External position detection system cable gland
⑪
Cable
⑫
EMC filter module cable gland
⑬
Input signal for positioner
21