Dometic MagicWatch Mode D'emploi page 10

Setting the system
Programming parameters
➤ Switch on the ignition and shift into reverse gear.
✓ The parking aid is switched on.
➤ Programme the required parameters according to fig. 9.
When you have finished programming:
➤ Disengage the reverse gear and then engage it again.
➤ Wait ten seconds.
✓ The parameters have now been changed and stored.
I
NOTE
To stop setting the parameters without saving your changes, or to
stop the entire setting process: refrain from pressing any buttons for a
while.
Suppressing the display of fixed objects (such as trailer hitches)
➤ Set parameter 10 so that fixed objects are not displayed (1 to 3).
Determining the installation position for the control electronics
➤ Parameter 14 determines whether the control electronics are installed on the left
or right side of the vehicle so that the shortest cable is installed to the left or right
sensors.
A
NOTICE! – Danger of malfunction
Set the parameter according to the installation position of the control
electronics. Otherwise display errors can occur.
Restoring the factory settings
➤ Press both buttons for longer than ten seconds.
✓ The display shows F5.
8
MagicWatch Accessory
EN