BORETTI BRA88 Mode D'emploi page 59

Positioning
Unpack the cabinet and check that it
is in good condition and free of any
transport damage.
The appliance must not be located
close to radiators or gas cookers.
Avoid prolonged exposure of the
appliance to direct sunlight.
For safety
ventilation must be as shown in Fig.
Attention: keep ventilation openings
clear of obstruction.
It is necessary that the niche is
provided with a conduct of venti-lation
having the following dimensions:
Depth: 50 mm
Width: 540 mm
The climate classification can be found
on the rating plate, which is located
inside the cabinet on the left hand wall.
The following table shows which ambient
temperature is correct for each climate
classification:
Climate
classification
SN
N
ST
T
reasons, minimum
for an ambient
temperature of
+10 to +32 °C
+16 to +32 °C
+16 to +38 °C
+16 to +43 °C
Electrical connection
Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply.
Voltage can vary by ±6% of the rated
voltage.
For operation with different voltages, a
suitably sized auto-transformer must be
used.
Important
The appliance must be earthed.
The power supply cable plug is provided
with a contact for this purpose.
If the domestic power supply socket is
not earthed. connect the appliance to a
separate earth in compliance with current
regulations, consulting a specialist
technician.
The Manufacturer
responsibility if the above safety
precautions are not observed.
This appliance complies with
the following E.E.C.
Directives:
- 87/308 EEC of 2/6/87 relative to
radio interference suppression.
- 73/23 EEC of 19.2.73 (Low Voltage
Directive)
modifications.
- 89/336 EEC
(Electromagnetic
Directive)
modifications.
declines
and subsequent
of 3.5.89
Compatibility
and subsequent
GB
all
59