Advice For Use - shark Vancore 2 Mode D'emploi

ADVICE FOR USE

A
D
HOLDING SYSTEM
Depending on the various versions and the
country concerned, your SHARK Vancore 2
helmet is equipped with a chin strap with a
"Precise Lock" rapid buckle with a snap lock.
The "Precise Lock" snap lock system gives you
precise and accurate adjustment because of
the considerable length of its notched section.
However, it is essential on purchase to adapt the
length of the chin strap to your measurements.
Adjust the length of the strap using the adjusting
buckle (Figs. A, B, C and D)
Choose your Vancore 2 and attach the holding
system. When the "Precise Lock" is adjusted to
the medium position, the chin
strap must be correctly tensioned under the chin
to hold the helmet firmly without causing you
any discomfort or pain.
8
B
E
To fasten the chin strap, all you have to do is to
thread the tongue into its place on the buckle
until tension is perfect (Fig. B).
The tongue connects and is automatically bloc-
ked. To release the chin strap, you have to pull
on the lever and remove the tongue from the
buckle. Although the notched tongue enables
you to change the adjustment precisely on each
use, it is important to check frequently that the
adjustment of the strap length is correct.
WARNING! never ride with the chin strap
loose or insufficiently tightened. Even
though the interior padding gives you the
impression of being held, your helmet risks
coming off in a fall. Never apply lubricating
or acid products or grease or solvents to the
chin strap buckle parts.
C
F
GO
The
gla
bee
foll
from
jec
The
an
ma
The
pea
crit
201
The
vis
The
nig
All
in a
The
pro