shark Vancore 2 Mode D'emploi page 9

GOGGLES
The helmet Vancore 2 must be exclusively used with
glasses of protection SHARK. The SHARK goggles have
been designed by one of the world leaders on the field,
following the highest standards, to protect your eyes
from water, dust, insects, stones and any kind of pro-
jectiles.
They are built with two screens: an outer shield and
an inner screen separated by an insulating air camera,
making it more difficult for it to be penetrated.
The SHARK goggles meet the requirements of the Euro-
pean EN 1938: 2010 F and are fully compliant with the
criteria of Class 2 of Directive 89/686/ECC EN 1938:
2010. They are identified by the number ACE 7600.
WARNING! For goggles SHARK the category
number of the filter is S1.
The range of light transmission is less than 75% of
visible light.
The goggles SHARK are "Not suitable for driving at
night or in the twilight".
All transmission profiles are based on data obtained
in accordance with ANSI Z80.3 EN 1938 and EN 1836.
The Shark goggles are equipped with an anti-scratch
protection film on the screen, this film helps against the
scratches but does not stop them from happening. It
is imperative to replace scratched or damage screens.
MAINTENANCE
For protection and improve its life, the outer surface of
your goggles Vancore 2 is anti-scratch treated. When
cleaning the lens, use lukewarm water (below 40
degrees) and a soft cloth in microfiber delivered with
goggles to wipe the lens. Neutral soap as "savon de
Marseille" can help you clean up.
WARNING! Never use any kind washing windows
(with alcohol or other solvent type), these products can
damage the screen treatment.
WARNING!
Never ride if your goggles are scrat-
ched, dirty, foggy or with your vision obscured in any
way, always ride with perfect visibility.
GOGGLES
9