Norcold 121XAC Serie Manuel D'installation page 16

2. Make sure that the side trim pieces [127] are in the
correct position (See Art01649 and Art01650):
- Slide both side trim pieces up or down as necessary
so that the ends of the side trim pieces are fully
covered by the upper and lower trim pieces [40 and
128].
- Pull the left hand side trim piece toward the left as far
as it will go so that there is no gap between the edge
of the side trim piece and the upper and lower trim
pieces.
- Pull the right hand side trim piece toward the right as
far as it will go so that there is no gap between the
edge of the side trim piece and the upper and lower
trim pieces.
- Push the refrigerator completely into the enclosure.
3. Install the mounting screws and trim:
- Put the upper trim piece [40] onto the front of the refrigerator
(See Art01649).
- Put the four screws [41] through the mounting flange on the
front of the refrigerator and into the enclosure wall.
- Put a cap plug [129] on each of the screw holes in the upper
trim piece on the front of the refrigerator.
!
WARNING:
Do not omit the lower trim piece. This
piece is part of the combustion seal.
Push the lower trim piece [128] onto the front of the refrigerator (See Art01650).
- Put the four screws [41] through the mounting flange on the front of the refrigerator and into the enclosure wall.
- Put a cap plug [129] on each of the screw holes in the lower trim piece on the front of the refrigerator.
- Put two or more screws through the mounting flange on the rear of the refrigerator and into the floor.
4. On metal door models only, you may wish to remove the protective packaging from the doors.
NOTE: Be careful to not scratch or dent the metal doors. Do not use any abrasive cleaners, chemicals, or scouring pads because
they can damage the fininish of the doors.
Installation Manual 16
127
Art01649
127 4
128
129 41 40
Art01650
129
127
127