Profroid GSB Notice D'instructions page 41

Figure 16
3.1 "Jog" feature
Figure 17
3.2 Crankcase heater (CCH) control
The sensor module contains an on-board CCH control relay. An auxiliary contactor is no longer required to turn the heater on when the
compressor turns off.
The appropriate voltage supply to the CCH power input terminals (115V/230V) is required.
The control of a 480V crankcase heater control is not supported by CoreSense.
The reset button below the control module may be used as an emergency shutdown, such as for clearing
liquid during a
3 seconds) the compressor will run again. The reset button may be pushed as necessary to stop the
compressor.
Reset button
start-up. After the module re-boots (approximately
41/78