Storch ProCut compact Mode D'emploi page 88

3. L cuts / pistol cuts at wall openings
Measure the distances (a and b, fig. 13) between the
already glued foam boards and the wall opening (e. g.
jamb / window frame) and transfer these measurements
to the insulating board being cut. Lay the plate onto the
bearing rail and position the vertical marking (a) exactly
below the wire of the corner cutter. Guide the wire as far
as to the horizontal marking (b) and stop there.
TIP:
It is more comfortable if the lock lever for reproducible
cuts (no. 10a, fig. 6) is adjusted to the horizontal dimen-
sion (b).
Now slide the foam board in the direction of the marking
- according to the desired cutout towards the left or the
right side.
Fig. 13
Window
Glued foam boards
Window
4. Plate cutouts for wall anchor /
mounting elements
Perform the steps with the corner cutter in the direction
of arrow.
Translation of the original instruction 88