Storch ProCut compact Mode D'emploi page 83

Mitre/bevel cut
This cut is executed in the same way as a mitre cut and
bevel cut. The board can also be mitred when executing
the bevel cut.
Rebate and section cut-out
Transfer the rebate dimensions to the foam board and
position the board on the bearing rail (no. 11, fig. 6).
Extract the cutting bow (no. 9, fig. 6) to the desired
rebate measurement - you can read the relevant dimen-
sion on the scale for section cut-outs (no. 19, fig. 6) on
the upper frame of the left side of the cutting bow. Undo
the fixing screw lock lever for the section cut-outs (no. 17,
fig. 6), slide the limiter as far as the stopper and re-se-
cure the screw. Guide the board to the left until the wire
has reached the end of the marking and then pull the
wire from the board.
When making a section cut-out repeat the previously
described process, but start by guiding the wire through
the board at the desired point up to the stopper. When
this area has been reached, the board is offset to the left
as far as the marking and then the cutting bow is remo-
ved from the board again.
Mitre / bevel cut
Rebate cut
Section cut-out
83 Translation of the original instruction