Storch ProCut compact Mode D'emploi page 82

Cutting variants
Straight cut (lateral cut)
Position the foam board on the bearing rails (no. 11, fig.
6), extract the cutting bow (no. 9, fig. 6), slide the foam
board to the left up to the cutting dimension (required
board width) (can be read on the measuring scale of the
bearing rail (no. 14 or 11, fig. 6), press the on / off switch
for a moment (LED illuminates in blue, wire warms up)
and then guide the cutting bow gently through the foam
board. To make repeated cuts of the same length, raise
the lock lever for repeat cuts (no. 16, fig. 6) and secure
it in place at the required measurement. In case other
lengths should be cut in between, it is possible to fold
out the lock lever, but which remains in position, and the
adjusted measure remains.
Mitre cut at walls
Take the mitre cut with the sliding bevel (included in deli-
very) at the object and position on top of the cross bar
of the cutting bow extension (see fig.6), undo set screws
(no. 8, fig. 6), swivel cutting bow (no. 9, fig. 6) to the
right side, as far as to the angle of the cutting bow and
the base plate correspond to the angle of the sliding
bevel. Tighten set screws (no. 8, fig. 6) again, position
the plate onto the bearing rail (no. 11, fig. 6) and guide
the wire through the plate.
Bevel cut
Transfer the slope to the foam board using a sliding bevel
(supplied) and position it on the bearing rail (no. 11, fig.
6). Extract the cutting bow, raise the lock lever for the
right bearing rail (no. 10, fig. 6) and the bearing rail (no.
11, fig. 6) with the foam board until the wire of the cut-
ting bow (no. 9, fig. 6) corresponds with the marking on
the foam board. Fix lock lever (no. 10, fig. 6) in position,
actuate on / off switch and guide cutting wire through the
plate. Should these cuts be repeated later, position the
adjusting lock lever for reproducible steps (no. 10a, fig. 6)
at this position. If the lock lever is now adjusted for the
right bearing rail for other cutting variants, it is possible
to return to the same mitre angle later.
Translation of the original instruction
Dimension determination by measuring
Lateral cut
Mitre cut
Bevel cut
82
Upper
dimension
Lower dimension