Storch ProCut compact Mode D'emploi page 78

Configuration / initial operation
Subsequently loosen the upper set screw (no. 8, fig. 3) for the cutting bow (no. 9, fig. 3), open it fully and then retigh-
ten the set screws (no. 8, fig. 3).
Undo the lock lever (no. 10, fig. 3) of the right bearing rail (no. 11, fig. 3), slide it down and fold the bearing rail to the
right side as far as to the stop. The bearing rail is now located at a 90° angle to the cutting wire. To ensure the foam
board is held securely unfold the board supports (no. 12b, fig. 3) as well.
Then, undo the retaining bolt (no. 13, fig. 3) of the left bearing rail (no. 14, fig. 3) and fold it out as far as to the stop.
Now insert the mains plug into the socket (230 V). The device is now ready for operation.
Fig. 3:
Front view, operating position (cutting bow and
bearing rail unfolded)
8 Set screw for cutting bow
9 Cutting bow
10 Lock lever for right bearing rail
10a Lock lever for reproducible cuts
11 Right bearing rail
12 Fold-out support
13 Retaining bolt for left bearing rail
14 Left bearing rail
15 On / off button with LED
16 Foldable lock lever for reproducible longitudinal cuts
17 Lock lever for reproducible section cut-outs
18 Board support
Translation of the original instruction
15
9
14 16
13
78
17
8
10a
18
10
12
11