Transportation & Storage; Maintenance Instruction; Service And Repair; Troubleshooting - RIDGID Seesnake Micro Mode D'emploi

When in use, the snake should easily maneuver itself into position going
forward.
TIP! The cable can be bent into a certain shape. This may help you maneuver
the cable into tight areas.
NOTE! The SeeSnake Micro was not designed to take the place of a drain
cleaner or electrical/plumbing fish sticks or tapes. In limited instances, the
SeeSnake Micro's accessories can be used to retrieve small items like dropped
rings or screws.
Transportation & Storage
1. Avoid exposing the unit to continuous vibration or extreme hot and cold
temperatures.
2. Always store the SeeSnake Micro indoors in the case it came with.
3. Always remove the batteries if the unit will not be used for an extended
period of time.
Maintenance Instructions
CAUTION: Make sure the batteries have been removed from the unit before
performing maintenance.
The SeeSnake Micro has been designed to require little maintenance.
However, in order to maintain its performance, you must always follow these
guidelines:
1. Always handle the device with care. It is not shock-resistant and should
not be banged or dropped. Treat it as you would any other sensitive opti-
cal device.
2. Always clean the imager head after use with soap and mild detergent.
3. Use only alcohol swabs to clean the connections.
4. Avoid rubbing too hard on the LCD. After use, wipe the display clean
gently with a dry cloth.
5. Do not disassemble this device beyond what is shown in the manual.
Doing so will void your warranty.

Troubleshooting

SYMPTOM POSSIBLE REASON
Display turns ON, but does not - Loose cable connections.
show image.
- Imager head covered by debris.
LEDs on imager head are dim - Batteries low on power.
at max brightness, display
switches between black and
white, color display turns itself
OFF after a brief period.
Unit will not turn ON. - Dead batteries.

Service and Repair

CAUTION: Tool should be taken to a RIDGID Independent Authorized Service
Center or returned to the factory. All repairs made by Ridge service facilities
are warranted against defects in material and workmanship.
If you have any questions regarding the service or repair of this machine, call
or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: TechServices@ridgid.com
For name and address of your nearest Independent Authorized Service Center,
contact the Ridge Tool Company at (800) 519-3456 or http://www.ridgid.com or
www.seesnake.com
POSSIBLE SOLUTION
- Check cable connections, clean if required.
- Re-attach.
- Visually inspect imager head to make certain it is not covered by debris.
- Replace batteries.
- Replace batteries.
Ridge Tool Company
SeeSnake Micro
® ™
Tools For The Professional
TM