Viewing; Cleaning; Storage; Service And Repair - RIDGID micro CA-25 Manuel De L'opérateur

micro CA-25 Inspection Camera
4. LED Brightness Adjustment: Turn the
LEDs ON. The imager head is equipped
with four white LEDs to aid inspection.
Use the + and – buttons to turn ON and
adjust the brightness of the LEDs.
5. Inspection: Insert the imager head and
cable into the space to be inspected. Do
not use the imager head or cable for any-
thing other than an inspection device.
Do not use the imag er head and cable to
clear a path. Do not force the imager
head and cable through tight bends or
spaces. These uses can damage the unit
and the area to be inspected.
6. Image Rotation: If needed, the image
seen on the screen can be rotated in
180 degree increments by pressing the
rotate image button.
7. Power Off: When the inspection is com -
plete, carefully withdraw the imager and
cable from the inspection area. Press
and Hold the power button for 1 second
to turn the unit OFF. The unit will automat-
ically turn OFF 30 minutes after the last
button press or if the batteries drop too
low.

Viewing

The micro CA-25 Inspection Camera can be
connected to a television or other monitor for
remote viewing or recording through the in-
cluded RCA cable. Open the rubber cover on
the side of the screen and insert the RCA
cable into the TV-OUT jack.
Insert the other end into the Video In jack on
the television or monitor. The television or
monitor may need to be set to the proper input
to allow viewing.
Figure 8 – TV-OUT Jack
8

Cleaning

WARNING
Remove batteries before cleaning.
• Always clean the imager head and cable
after use with mild soap or mild detergent.
• Gently clean the LCD with a clean dry
cloth. Avoid rubbing too hard on the LCD.
• Wipe the hand held display unit down with
a clean, dry cloth.

Storage

The RIDGID micro CA-25 Inspection Cam era
must be stored in a dry secure area between
-4°F (-20°C) and 140°F (60°C).
Store the tool in a locked area out of the
reach of children and people unfamiliar with
the micro CA-25 Inspection Cam era.
Remove the batteries before any long period
of storage or shipping to avoid battery leak-
age.

Service and Repair

WARNING
Improper service or repair can make the
RIDGID micro CA-25 Inspection Camera
unsafe to operate.
RIDGID tools are warranted to be free of de-
fects in workmanship and material. Should
this product require service:
• Contact Ridge Tool Technical Service De -
part ment at rtctechservices@emerson.com,
or in the U.S. and Canada call (800) 519-
3456
• Visit www.RIDGID.com or www.RIDGID.eu
to find your local RIDGID contact point.
• Return to place of purchase.

Disposal

Parts of the RIDGID micro CA-25 Inspection
Camera contain valuable materials and can be
recycled. There are companies that specialize
in recycling that may be found locally. Dispose
of the com ponents in compliance with all ap-
plicable regulations. Contact your local waste
management authority for more information.