Reset Function; Accessories; Storage; Service And Repair - RIDGID micro CA-330 Mode D'emploi

micro CA-330 Inspection Camera
• Always clean the imager head and cable
after use with mild soap or mild detergent.
• Gently clean the display screen with a
clean dry cloth. Avoid rubbing too hard.
• Use only alcohol swabs to clean the cable
connections.
• Wipe the hand held display unit down with
a clean, dry cloth.

Reset Function

If the unit stops functioning and does not op-
erate, press the Reset Button (under the left
side port cover – Figure 4). The unit may re-
cover to normal operation when re started.

Accessories

WARNING
To reduce the risk of serious injury, only
use accessories specifically designed
and recommended for use with the
RIDGID micro CA-330 Inspection Camera
such as those listed below. Other Ac ces -
sories suitable for use with other tools
may be hazardous when used with the
micro CA-330 Inspection Camera.
micro CA-330 Inspection Camera
Accessories
Catalog
No. Description
37108 3' (90 cm) Cable Extension
37113 6' (180 cm) Cable Extension
37103 Imager Head and Cable - 17 mm
37098 1m length 6mm diameter imager
37093 4m length 6mm diameter imager
37123 17mm Accessory Pack (Hook,
Magnet, Mirror)
40028 AC Adapter
40623 Headset Accessory with
Microphone
Further information on accessories speci fic
to this tool can be found in the RIDGID
Catalog and online at www.RIDGID.com or
www.RIDGID.eu.

Storage

The RIDGID micro CA-330 Inspection Cam -
era must be stored in a dry secure area be-
tween -4°F (-20°C) and 158°F (70°C) and
humidity between 15% and 85% RH.
Store the tool in a locked area, out of the
14
reach of children and people unfamiliar with
the micro CA-330 Inspection Cam era.
Remove the battery before any long period of
storage or shipping to avoid battery leakage.

Service and Repair

WARNING
Improper service or repair can make the
RIDGID micro CA-330 Inspection Camera
unsafe to operate.
Service and repair of the micro CA-330 In -
spec tion Camera must be performed by a
RIDGID In dependent Service Center.
For information on your nearest RIDGID In -
depen dent Service Center or any service or
repair questions:
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or www.RIDGID.eu
to find your local RIDGID contact point.
• Contact Ridge Tool Technical Service De -
partment at rtctechservices@emerson.com,
or in the U.S. and Canada call (800) 519-
3456.

Disposal

Parts of the RIDGID micro CA-330 Inspection
Camera contain valuable materials and can be
recycled. There are companies that specialize
in recycling that may be found locally. Dispose
of the com ponents in compliance with all ap-
plicable regulations. Contact your local waste
management authority for more information.
For EC Countries: Do not dispose
of elec trical equipment with house-
hold waste!
According to the European Guide -
line 2012/ 19/EC for Waste Elec -
trical and Electronic Equipment
and its imple men tation into national legislation,
electrical equipment that is no longer usable
must be collected separately and disposed of
in an environmentally correct manner.