gala gar CUT 350 K G.E. Manuel Technique D'instructions page 15

3.2 OPERATION SEQUENCE TO START UP THE EQUIPMENT
1. Select and fit the type of accessories depending on the work to carry out. (See section 3.3).
2. Connection power supply plug to the mains.
3. Connect ground to the part to be cut
4. Connect the equipment and regulate the desired welding current with potentiometer "2" Figure 2.
5. You can now begin the cutting operation. (See section 3.4).
3.3 SELECTING AND FITTING ACCESSORIES.
PART THICKNESS AND SHAPE
WEAR
CUTTING SPEED
SEPARATION TO PART
STEEL
ALUMINIUM
STAINLESS
GALA CUT 350 K G.E.
Nozzle Ø = 0.9 (40 A)
UP TO 15 mm
LOW
HIGH
CONTACT
THICK- CUT SPEED
0,20 m/min
12 mm 5 mm
10 mm 5 mm
8 mm 2.5 mm
Long Nozzle Ø = 0.9 (40 A)
Corners and difficult accesses
LOW
NORMAL
CONTACT
2.5 m/min
1.0 m/min
m/mín
2.5 mm
3 mm
1 mm
Pág. 15