Storch EcoFinish HVLP Mode D'emploi page 69

c) Avoid accidental starting. Ensure the switch is in the off position before plugging in. Carrying power
tools with your finger on the switch or energising power tools that have the switch on invites accidents.
d) Do not overreach. Keep proper footing and balance at all times. This enables better control of the
power tool in unexpected situations.
e) Wear suitable clothing. Do not wear loose clothing or jewellery. Keep your hair, clothing, and gloves
away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts.
4. Power tool use and care
a) Never overload the power tool. Always work within the stated output range.
b) Do not use the power tool if the switch does not turn it ON and OFF. Any power tool that cannot be
controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source before making any adjustments, changing accessories, or
storing the tool. This safety measure will prevent the tool from starting accidentally.
d) Keep any power tools that are not being used out of the reach of children. Do not allow to use this
power tool to persons who are not familiar with it or who haven't read these instructions. Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any
other condition that may affect the power tool's operation. If damaged, have the power tool repaired before
use.
f) Use the tool and accessories, etc., in accordance with these instructions and in the manner intended
for the particular type of power tool, taking into account the working conditions and the work to be perfor-
med. The use of power tools for applications other than those intended can lead to dangerous situations.
5. Support
Maintenance and repairs must be performed by qualified STORCH staff or an authorised STORCH Service
Partner. Only use earthed electrical outlets.
Specific safety rules for HVLP Sprayers OBSERVE ALL WARNINGS!
This equipment is for professional use only.
WARNING: FIRE AND EXPLOSION HAZARD.
Take all safety precautions necessary to avoid ignition sources during spraying. The system must be at least
8 metres from the surface to be coated.
WEAR PROTECTIVE EQUIPMENT AT ALL TIMES.
Always use a respirator, eye protection and protective clothing and gloves.
RISK OF EXPLOSIONS DUE TO HALOGENATED HYDROCARBON SOLVENTS
Never use halogenated hydrocarbon solvents in this machine. Contact with aluminum parts may cause an
explosion. Some of the most common of these solvents are: Carbontetrachloride, Chlorobenzene, Dichloroe-
thane, Dichloroethy l Ether, Ethylbromide, Ethylchloride, & Tethrachloethane.
69 Translation of the original instruction