Sensor Installation Procedure; Figure 2-2 Sample Sensor Label - Siemens SITRANS F FUT1010 Instructions De Service

Install/mounting

2.4 Sensor Installation Procedure

Hot Surface
External spool temperature can exceed 93°C (200°F). If this surface is contacted, the
potential for injury exists.
To reduce the risk of injury allow the surface to cool before touching.
Sensor Failure
Exceeding rated pressure identified as MAOP may cause Sensor failure and the potential
for injury.
Check all pressure ratings before installing sensors.
Figure 2-2
2.4 Sensor Installation Procedure
Pre-Installation Check List
All Sensors are assembled with the final transducers and are mated to the selected
transmitter electronics prior to delivery. The transmitter is pre-programmed with the
installation parameters specific to this Sensor, therefore the installer should verify that the
transmitter serial number matches the transmitter serial number indicated on the Sensor
nameplate.
Perform the following checklist before installing the Sensor into the line:
1. Verify that the line operating conditions (flow velocity, pressure, temperature range) and
2. Verify that the transmitter electronics is paired with the serial number listed on the Sensor
16
WARNING
WARNING
TM
TransLoc
Hazardous information here.
May vary depending on model
purchased.
Install per Siemens Dwg. A5E02716838A
Sample Sensor Label
line MAOP are within the limits specified for the flowmeter.
nameplate.
SYSTEM P/N
S/N
SENSOR P/N
S/N
TRANSMITTER P/N
S/N
TM
WideBeam TRANSDUCER P/N
DOM
FUT1010 IP65 NEMA 4X & IP66 NEMA 7 Gas Quick Start
Siemens Industry, Inc
Industry Automation
Spring House, PA
METER SIZE / CL
I.D .
WEIGHT
MAT BODY/FLANGE
BODY DESIGN CODE
FLANGE DESIGN CODE
Qmin/Qmax
Min OP / MAOP
OP TEMP
STORAGE TEMP
DOT
TEST PRESSURE (BAR)
IP65 / NEMA 4X
A5E02639002 Rev.04
Operating Instructions, 1/2013, A5E02639183-AC