Dantherm Elvarmeunit Guide D'installation page 13

Electric installation of the electric heating unit
Illustration Use the following illustration in connection with the procedure described below:
Procedure Follow these guidelines for the installation of the electric heating panel:
NB: All cables are led into cable trays to keep them in order!
Step
1 Dismantle the 3 front panels to get access to the control panel. This is done
by removing the 8 screws on the front panels
2 Connect the wires from the grey cable as follows:
3 × sort black wire in thermo switch together with the already
mounted wires
Wire 1, 2 and 3 in L1, L2 and L3, respectively
3 Connect the wires from the black cable as follows (they are numbered):
Wire 1 in terminal 5
Wire 2 in terminal 6
Wire 3 in terminal 7
Wire 4 in terminal 8
4 Mount the bridge between terminal 3 and 4 of the terminal strip
Action
13