What To Do If Trouble Occurs; Replacing The Oven Lamp; Replacing The Door Sealing; Rating Label - Kuppersbusch EEB 6200.0 Instructions D'utilisation Et Avis De Montage

What to do if trouble occurs...

Repairs may only be carried out by a qualified technician!
You can deal with some problems that occur yourself. First check whether
there has been any operating error. Repairs during the guarantee period are
not free of charge, when they are caused by operating errors or non-
observance of the following instructions:
Fault Cause
Not possible to switch off the Electronic component
oven. defective.
Oven does not heat up. Fuse defective.
Is the mains plug in
the wall socket?
Oven temperature
control or mode
selector has not been
switched on.
Electronic timer
flashing – the clock
has not yet been set.
Oven light no longer works. Lighting defective.
Glass of oven door broken.
Door sealing damaged.
Strong smells from oven in
ökotherm
®
spite of ökotherm catalyst.
must be regenerated.
Strong vinegar smell when Baking with sour
preparing. dough or with yeast,
food containing alcohol
and using a fan-
assisted mode.
Fruit juice or protein stains Moist cake or meat
on enamelled parts. juices.

Replacing the oven lamp

Caution: Danger of electric shock! Before you open the cover of the
oven lamp the appliance has to be disconnected from the electricity
supply: Switch off the fuse or pull out the mains plug!
It is imperative to allow the appliance and lamp to cool down before you
replace the lamp. The lamps become very hot after being in use for some
time.
Type: 25 W, 230/240 V, socket: E14
Important: temperature resistant up to 300 °C!
You can obtain these lamps from KÜPPERSBUSCH customer service or from
your dealer.
EEB 6200.0
Remedy
Disconnect fuse, call
customer service.
Check and replace fuse, if
necessary.
Plug the mains plug into the
wall socket
Set oven temperature control
or mode selector as required.
Set the clock. See page 19.
Replace the oven lamp.
Switch off the appliance,
call customer service.
Replace the door sealing.
®
Heat the empty oven by
catalyst
intensive hot air convection
at 275 °C for 60 min.
Use a mode without fan-
assistance, e.g., top heat/
bottom heat.
Harmless changes in the
enamel, cannot be remedied.
Changing the light bulb:
– Unscrew the shelf rack.
– Carefully lever out the glass
cover with a screwdriver.
– Remove the damaged light
bulb and put the new one in.
– Reinstall the glass cover.

Replacing the door sealing

Do not use the oven with damaged or missing door sealing!
If the sealing is damaged or cannot be cleaned anymore it has to be replaced.
You can obtain a new sealing from KÜPPERSBUSCH customer service.
Removing the sealing
– To remove the sealing gently pull
each corner out.
Fitting the new sealing
– Clasp one corner after the other into the oven front.
Take care not to deform the hooks!

Rating label

Always indicate the data provided on the rating label when calling in customer
service or ordering spare parts.
The rating label for the oven is located on the
right-hand side strip and is visible when the
oven door is open.
– Make a note of this information in case you
have to consult our customer service.
Production-no. oven
Model designation oven
27