Cleaning And Care; Hob; Oven; Regenerating The Ökotherm ® Catalyst - Kuppersbusch EEB 6200.0 Instructions D'utilisation Et Avis De Montage

Cleaning and care

Make sure that the appliance and the control panel have cooled down
completely before cleaning!
Do not use any abrasive or aggressive cleaning or scouring agents such as
steel wool, soap-impregnated steel wool, metal or plastic sponges or similar
agents with an abrasive surface.
Do not use any cleaning agents with a bleaching effect or containing
chlorine.
Alkaline cleaning agents and oven sprays can damage the surfaces
(particularly aluminium). Only use neutral cleaners or washing-up liquids for
cleaning the cooker.
Usually it is sufficient to clean the appliance with a damp cloth and a little
washing-up liquid each time you use it. Wipe dry afterwards.
After cleaning make sure that all the cleaning agent has been thoroughly
removed.
Remove any deposits of calcium or any spots of grease, starch or egg-white
as soon as possible. If this is neglected, corrosion can develop under these
deposits on stainless steel surfaces due to the lack of oxygen.

Hob

When cleaning stainless steel appliances please use the usual cleaning
agents for stainless steel. Please take note of the instructions of the
respective manufacturers and try out products on small surfaces first before
spreading the cleaning agent over the entire surface.
Clean a stainless steel hob with a commercially available stainless steel
cleaning agent.
Clean a glass ceramic hob, enamel hob and hotplates with a moist cloth
and some washing-up liquid.
Remove incrustations and spilt food from glass ceramic cooking surfaces
with a cleaning scraper. Remove sugar and melted plastic immediately while
the cooking surface is still hot.

Oven

From time to time the oven needs to be cleaned thoroughly.
Never wipe an open grill socket! No water or oven spray may enter it!
When cleaning we recommend to remove the door sealing (page 27) to
avoid that dirt can collect between sealing and ovenfront. Clean the
sealing if necessary with a warm water and a little detergent.
®
The backmobil (special accessory 600) can be dismantled for cleaning.
Please observe the instructions enclosed with the backmobil
Removing the oven door
– Open the oven door as wide as it will
go.
– Fold forward the clamps on the door
hinges.
26
– Take hold of the oven door on the
both sides and close it almost
completely.
– Gently lift the door and pull the
hinges forward away from the door
opening.
Removing the side racks
– Loosen the screws.
– Remove the slot-in racks.
Reassembling
Installing side racks
– Insert side racks and tighten down in front.
Reassembling the oven door
– Take hold of the oven door on both
sides and push the hinges into the
relevant holes on the oven. The hinge
will click into place.
– Slowly open the oven door full.
®
.
– Fold back the clamps on the door
hinges.
– Close the oven door.
Regenerating the ökotherm
– Heat the empty oven by Intensive hot air convection
60 min.
®
catalyst
and at 275 °C for
EEB 6200.0