EUROM Golden 2000 Amber Smart Manuel D'utilisation page 31

- or the socket you want to use gives the correct tension (220-240V~50Hz) and is
grounded.
If everything is all right you can insert the plug into the socket.
The Golden 2000 Amber Smart has a remote control that works with two batteries:
AAA, 1.5V.
While using, point the remote control to the receiving point of the heater. If there
are obstacles between remote control and the heater, it will not work!
 Press the on/off switch (5) on the side of the unit to "I" (on); The blue light on
the reception point will go on.
 Set the device into operation by pressing the ON
button of the remote control. The device has a
'slow start' at 33% output. 4 seconds after
starting, it automatically switches to the most
recently used output. On first use, it will switch
to 100% output after 4 seconds.
 With the Ʌ-arrow, you can switch to a higher
heating level
 With the V-arrow, you can switch to a lower
heating level
 Pressing on the MAX button takes you straight to
the highest heating level.
 To stop the unit, first press the 'off' button on the remote control. Then turn it
off by pressing the on/off-switch (5) to 'O' (off). Finally, unplug it from the wall
outlet. Allow the heater to cool down.
Warning!
 When you turn off the unit using only the remote control (or the app), the
'standby' remains. So turn it off using the remote control (c.q. the app) or the
on/off-switch and remove the plug from the socket!
 Remove the batteries out of the season, that will extend the life of the remote
control.
 When you use the appliance for the first time (or after a long time again),
observe it during the first 10 till 15 minutes to be sure that is works trouble-free.
The reset button
You can use the reset button in three situations (see below):
- To operate the device without the remote control. Every time that you press the
reset button (briefly), the output changes from: > 2000 W > 1320 W > 660 W >
off.
- To switch the device back on without the remote control, after the shock
safeguard has turned it off (see: Shock safeguard).
- To set or change the password for the app control.
Control with Bluetooth and Eurom Heating app
Using the app, you can: remotely switch the device On and Off - continuously
regulate the heat output from 0 to 100% - Set a timer to switch off the device
automatically – set multiple devices individually.
31