Table des Matières
Publicité
ENGLISH
- SUN: allocation of profile to Sunday: possible values
are P1 and P2
HA Option
This option is available only on models equipped with HA
module, and only if operation of the main system with
time profiles has not been enabled. Selecting HA by
pressing SET, the settings for HA operating mode are
accessed. The parameters are:
24
24
FILT
1
2
3
esc
/ °C
By-Pass
- En (Enable): possible values are:
PROF: enables HA mode with profiles
ON: enables HA mode continuously
OFF: disables HA mode
HOL: enables HOLIDAY mode: two hours antibacterial
operation per day, two hours refresh, 20 hours stand-
by.
If EN PROF has been selected, the following parameters
are also enabled:
- ST: start time, profile P1
- EN: end time, profile P1
- ST1: start time, profile P2 interval 1
- EN1: end time, profile P2 interval 1
- ST2: start time, profile P2 interval 2
- EN2: end time, profile P2 interval 2
- MON: allocation of profile to Monday: possible values
are P1 and P2
- TUE: allocation of profile to Tuesday: possible values
are P1 and P2
- UED: allocation of profile to Wednesday: possible
values are P1 and P2
- THR: allocation of profile to Thursday: possible values
are P1 and P2
- FRY: allocation of profile to Friday: possible values are
P1 and P2
- SAT: allocation of profile to Saturday: possible values
are P1 and P2
- SUN: allocation of profile to Sunday: possible values
are P1 and P2
P1
P2
HA
4
5
6
7
set
Prg
View alarm menu (fig.25)
Before proceeding with the steps indicated below, press
the ESC button to exit and return to the initial menu.
25
25
FILT
1
2
3
esc
Prg
/ °C
By-Pass
The indication of any alarm conditions that may have
been tripped can be displayed as follows:
--press and hold the SET button
--press and release the UP or DOWN button to view
ALRM menu
--press and release the SET button to view the active
error code The various alarm situations that can affect
the system are displayed on the user panel as follows:
ti: indoor temperature sensor faulty; contact Technical
Support for assistance;
tout: outdoor temperature sensor faulty; contact
Technical Support for assistance;
te: exhaust air temperature sensor faulty; contact
Technical Support for assistance;
preh: preheater faulty or missing (if applicable); contact
Technical Support for assistance;
Hito: outdoor temperature higher than 45 °C; contact
Technical Support for assistance;
Hiti: indoor temperature higher than 45 °C; contact
Technical Support for assistance;
Filt: clogged filters need replacing (2 months). Once new
filters have been fitted, the error can be reset by the user:
this is done simply by pressing and holding the UP and
DOWN buttons together.
N.B. Manually resettable errors can be removed by
pressing and holding the UP and DOWN buttons
together.
P1
P2
HA
4
5
6
7
set
25
Publicité
Table des Matières
